To return to the Product listing, please click this line.

General Purpose Plastisol Ink – GP Series
For use with 100% Cotton White and Light-Colored Garments

Low Viscosity & Soft Hand Finish
Phthalate Free
Ready to use plastisol ink for light-colored textiles
In Compliance with CPSIA (Consumer Product Safety Improvement Act-2008) Section 101 Lead Content in substrates (<300 ppm lead) as Section 108 Phthalates (<.1% DBP DEHP, DINP, DIDP)

STOCK, END-USE: Cotton, 50/50 cotton/polyester blends, and some

DESCRIPTION: GI-GP Series is formulated with a unique low viscosity and perfect consistency for printing straight from container.

GI-GP Series may eliminate the need for modifiers and save production time in the process. It provides super soft-hand finish on most textile substrates, especially white and light-colored garments.

Note: Pre-test on actual substrate before any full production run, for adhesion, wash fastness and other desired effects.

FINISH: Durable, soft-hand finish.

COLORS: Available low-bleed opaque colors; formulated using non-leaded pigments.

SCREEN FABRIC: Mesh counts up to 355 mono-filament polyester (142T European Mesh).

STENCIL: Dual-sensitized direct method photo emulsion or SBQ pre-sensitized photo emulsion or equivalent

CURE/DRYING: Heat-cure at approximately 320°F (160°C) for 1 to 3 minutes. Will not air-dry.

MODIFICATIONS: To reduce ink viscosity with RE703 or RE704, add 5% or less (by weight of ink). Reducer is to be used very sparingly and only when necessary. RE705 can be added up 10 to 20% (by weight of ink) if the color shade is not critical.

SQUEEGEE: When printing textiles, use a medium to hard (65-85 durometer) squeegee.

STORAGE: Plastisol responds to heat. Always store at cool room temperatures below 90°F (32°C). Avoid exposing inks to elevated temperatures before printing.

PACKAGING:
1- quart (0.945 Liter)
1-gallon (3.78 Liters)
5-gallon (18.9 Liters) containers.

Drums available in 30-gallon (113.4 Liters) and 55-gallon (207.9 Liters) by Special telephone Order

SAFETY & HANDLING: Refer to Material Safety Data Sheet (MSDS) for complete information

WASH UP SOLVENT:  Use T-125 wash up or equivalent. SC-510 Biodegradable wash up.  (Non-Petrochemical)

MODIFIERS: Clear Extender GI-GP 081, Base GI-GP 084, Softness Enhance Base RE 703, Quick Flash Reducer RE 704, Clear Reducer RE 705, Curable Reducer GI-GP081, Extender Base GI-GP084